Background
An equipment integrator / manufacturer in Consumer electronics needed to metered filling on a acoustic component using two-component epoxy.
Process challenge
Micro-litre volumes with expensive material and no waste allowed.
Solution
We recommended Screw Valve + Dispensing Valve, with using a precision dispensing valve with suck-back and servo three-axis motion for uniform coating.
Result
- Overall equipment availability improved by about 12%.
- Shot volume 0.1 mL with deviation within ±3%.
- Cycle time 0.6 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Consumer electronics
- Workpiece: acoustic component
- Fluid: two-component epoxy
- Process: metered filling
- Recommended lines: Screw Valve, Dispensing Valve
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site