Background
An equipment integrator / manufacturer in Automotive electronics needed to sealing and bonding on a pressure sensor using filled thermal gel.
Process challenge
High fluid viscosity and resistance causing pneumatic extrusion to lose speed.
Solution
We recommended Pneumatic Valve + Glue Supply System, with using a precision dispensing valve with suck-back and servo three-axis motion for uniform coating.
Result
- Setup time cut from 40 minutes to under 15 minutes.
- Shot volume 4 mL with deviation within ±3%.
- Cycle time 0.3 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Automotive electronics
- Workpiece: pressure sensor
- Fluid: filled thermal gel
- Process: sealing and bonding
- Recommended lines: Pneumatic Valve, Glue Supply System
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site