Background
An equipment integrator / manufacturer in Automotive electronics needed to metered filling on a harness connector using two-component epoxy.
Process challenge
Large potting volume where voiding and incomplete fill are hard to balance.
Solution
We recommended Pneumatic Valve + Glue Supply System, with using a precision dispensing valve with suck-back and servo three-axis motion for uniform coating.
Result
- Overall equipment availability improved by about 12%.
- Shot volume 4 mL with deviation within ±3%.
- Cycle time 0.9 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Automotive electronics
- Workpiece: harness connector
- Fluid: two-component epoxy
- Process: metered filling
- Recommended lines: Pneumatic Valve, Glue Supply System
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site