Automotive electronics ECU unit potting: instant adhesive case study

Background

An equipment integrator / manufacturer in Automotive electronics needed to potting on a ECU unit using instant adhesive.

Process challenge

Particle fillers settling and clogging after long idle periods.

Solution

We recommended Pneumatic Valve + Glue Supply System, with pairing a micro screw valve with a level sensor in closed loop for accurate volumetric output.

Result

Volume drift held within ±3% over an 8-hour run.
Shot volume 4 mL with deviation within ±3%.
Cycle time 0.3 s per dot with no stringing or dripping during continuous running.

Project facts

Industry: Automotive electronics
Workpiece: ECU unit
Fluid: instant adhesive
Process: potting
Recommended lines: Pneumatic Valve, Glue Supply System

Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.