Background
An equipment integrator / manufacturer in Optoelectronics and display needed to potting on a light guide assembly using silicone sealant.
Process challenge
Large potting volume where voiding and incomplete fill are hard to balance.
Solution
We recommended Dispensing Valve + Glue Distributing Machine, with using a servo dispensing module with a programmable speed profile to hold a constant extrusion rate.
Result
- Material utilisation improved by about 8% with visibly less waste.
- Shot volume 1.5 mL with deviation within ±2%.
- Cycle time 0.5 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Optoelectronics and display
- Workpiece: light guide assembly
- Fluid: silicone sealant
- Process: potting
- Recommended lines: Dispensing Valve, Glue Distributing Machine
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site