Background
An equipment integrator / manufacturer in Optoelectronics and display needed to potting on a display bezel using filled thermal gel.
Process challenge
Particle fillers settling and clogging after long idle periods.
Solution
We recommended Dispensing Valve + Glue Distributing Machine, with replacing time-pressure control with a positive-displacement screw valve to meter by volume.
Result
- Volume drift held within ±3% over an 8-hour run.
- Shot volume 4 mL with deviation within ±2%.
- Cycle time 0.5 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Optoelectronics and display
- Workpiece: display bezel
- Fluid: filled thermal gel
- Process: potting
- Recommended lines: Dispensing Valve, Glue Distributing Machine
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site