Background
An equipment integrator / manufacturer in Optoelectronics and display needed to coating on a LED module using two-component epoxy.
Process challenge
High fluid viscosity and resistance causing pneumatic extrusion to lose speed.
Solution
We recommended Dispensing Valve + Glue Distributing Machine, with using a servo dispensing module with a programmable speed profile to hold a constant extrusion rate.
Result
- Material utilisation improved by about 8% with visibly less waste.
- Shot volume 4 mL with deviation within ±2%.
- Cycle time 1.1 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: Optoelectronics and display
- Workpiece: LED module
- Fluid: two-component epoxy
- Process: coating
- Recommended lines: Dispensing Valve, Glue Distributing Machine
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site