Background
An equipment integrator / manufacturer in New energy and storage needed to sealing and bonding on a prismatic battery cell using UV-curing structural adhesive.
Process challenge
Very small shot volume with high repeatability demands, plus overflow and stringing risk.
Solution
We recommended Glue Supply System + Screw Valve + Glue Distributing Machine, with adding regulated supply with a drum pump for continuous feed to suppress pressure ripple.
Result
- Overflow and stringing defects reduced by roughly 60%.
- Shot volume 0.05 mL with deviation within ±2%.
- Cycle time 1.1 s per dot with no stringing or dripping during continuous running.
Project facts
- Industry: New energy and storage
- Workpiece: prismatic battery cell
- Fluid: UV-curing structural adhesive
- Process: sealing and bonding
- Recommended lines: Glue Supply System, Screw Valve, Glue Distributing Machine
Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.
Scan to visit our site