Medical and consumables medical catheter metered filling: two-component epoxy case study

Background

An equipment integrator / manufacturer in Medical and consumables needed to metered filling on a medical catheter using two-component epoxy.

Process challenge

Particle fillers settling and clogging after long idle periods.

Solution

We recommended Screw Valve + Sensor, with tuning rotor/stator fit and flow path geometry to the filler particle size.

Result

• Setup time cut from 40 minutes to under 15 minutes.
• Shot volume 0.1 mL with deviation within ±2%.
• Cycle time 1.0 s per dot with no stringing or dripping during continuous running.

Project facts

• Industry: Medical and consumables
• Workpiece: medical catheter
• Fluid: two-component epoxy
• Process: metered filling
• Recommended lines: Screw Valve, Sensor

Note: this case is placeholder demo content showing the structure of the section. Replace it with real project data before publishing.